Sunday, August 7, 2016

DIY: How to replace rear wheel hub bearing in Acura RSX Honda DC5

DIY: How to replace rear wheel hub bearing in Acura RSX Honda DC5

TOOLS:
- gloves
- jack and jack stands
- 12, 14, 1-1/4 nuts
- impact wrench
- screw driver 
- hummer
- needle nose pliers

1. Jack the car up and remove rear wheel
2. Remove brake caliper and brake pads.
3. Remove one nut holding brake line.
4. Remove 2 small screws holding rotor, yes I used that 20" bad boy! :)
5. Remove axle nut, I was able to take it off with my cordless impact wrench, little surprise here.
6. Remove old hub and install the new one.










1 comment:

  1. i wonder if you can just change the bearing inside and push them out

    ReplyDelete